Fluidall LLC
Assembly Instructions
2 Tank Gravity Feed System Components:
• Poly Tank(s)
• Steel 24″H Stand
• Drip Tray Assembly
• Gravity Feed Kit (Valves and Fittings)
(1) – 1” 90° Male Barb (PF90)
(1) – 1” Stub Barb (PFSB)
(2) – Hose Clamps (PHC1)
(1) – 1”D Plastic Tubing (PTFT)
(2) – Dispensing Valves (SR1)
(1) – 90° Steel Elbow (EBM)
(1) – Tube of Threading Sealant (REC5)
Step 1
Invert stand on concrete base with elbow mount holes to front. Hand tighten 4 legs into couplings, then torque 1/2 to 1 full turn with pipe wrench.
NOTE: Stand can be leveled by adjusting leg heights.
Step 2
Slide drip tray frame down front legs: tighten set screw to hold in place. Lift stand right side up and place in prepared location (see note). Adjust drip tray to desired height and tighten. Insert catch trays in frame.
NOTE: If configuring with secondary containment, place stand inside containment vessel.
Step 3
Stack one tank on top of assembled stand with bulkhead and fill port facing outward. Align front of tank with front edge of stand (front edge has pre-drilled holes).
Stack top tank and secure placement onto bottom tank’s groves.
Step 4
Bolt elbow to the stand’s centermost predrilled holes.
Step 5
Apply thread sealant to:
A) Stud barb. Hand-tighten into top of elbow.
B) Dispense valve (top tank). Hand-tighten into front of elbow.
C) Dispense valve (bottom tank). Hand-tighten into bottom tank bulkhead.
Torque each 1/2 to 1 full turn with wrench.
Step 6
Apply thread sealant to 90° male barb and hand tighten into top tank bulkhead fitting. Torque 1/2 to 1 full turn with wrench until facing five o’clock position.
Step 7
Cut plastic tubing to length, if needed. Place a hose clamp on each end of tubing. Secure tubing to the upper tank’s 90° male barb, and the other end onto the stud barb. Secure hose clamps using screwdriver.
Source: http://www.fluidall.com/bulk-tank-assembly/