How It's Done
Line-X is like the soles of your work boot… but sprayed onto your truck bed. Any thickness… from 1/16" to 1". |
LINE-X exhibits the highest tensile strength, the highest tear strength, and the highest abrasion resistance than any other spray-in liner available. This makes LINE-X the highest performing bed liner.
LINE-X is a two part polyurethane elastomer system. It uses equal parts of an “A” component or hardener and a “B” component or resin. When combined properly it produces a polyurethane elastomer similar to the bottoms of your work boot.
The two liquid components are brought together (using special equipment) at the tip of the spray gun. LINE-X cures or “sets up” in 3 to 5 seconds, giving it an immediate set time.
100% bond to virtually any surface.
Dries the fastest–Easier to apply.
Faster turnaround time.
Best looking.
Environmentally safe–no VOCs or CFCs, 100% solids.
EPA exempt.
80%+ physical properties to -50°
Withstands temperatures as high as 350° +
From start to finish it took about 2 hours for one experienced person to complete the job. The truck is ready for use immediately–even in the rain or cold, without affecting the material.
The non-skid LINE-X surface holds loads in place. Plus, it won't tear or rip like other “soft” spray on bedliners.
Applying Line-X - 5 Steps
1. On a clean, dry truck the bed is masked as if it is to be painted. | |
2. The entire truck is covered to protect from overspray. | |
3. The bed is wiped with a grease and wax remover, scuffed... and it's spray time! | |
4. Sprayed on, it dries in 3-5 seconds. It's ready for heavy use (shoveling out gravel) in 24 hours. LINE-X is the THICKEST of all spray on bedliners. | |
5. Immediately after spraying, the truck is unmasked. |
Source: http://www.line-x.ca/index.php?page=how