HARTL PC12701 (2007) - Unit #I3877
$279,000.00
$279,000.00
Caterpillar C11 Engine
28" x 49" Inlet Opening
8' x 10' Vibratory Feeder
Hopper Wings
48" Rear Discharge Conveyor
2007 CP20/200 SC2 - 30" Magnet
15" Pads
Hydraulic Drive
Rated for up to 250 Tons per Hour
Rated at 385 HP.
Approximately 75,000 LBS.
Repair / Condition Report
Total Idle Hours: 386 at 1566 Hours
• Upon arrival, this unit was serviced.
• Engine oil filter was cut open and it was clean.
• Hydraulic filter was also cut open and it was clean as well.
• Complete unit was inspected for needed repairs.
Following are the repairs completed by Marcel Equipment Limited at 1553 hours:
• Inspected and measured all internal wear plates and replaced if not within specifications.
• Checked all control panel lights for proper operation.
• Repaired the ground switch.
• Repaired the leak on the crush adjusting cylinder.
• Checked the travel pressures and set them to 4060 PSI.
• Repaired the wiring to the vibrating hopper solenoid.
• Installed a NEW crusher V pulley flywheel.
• Installed a NEW crusher shaft bearing on the pulley side.
• Installed a NEW carrier roller on the main belt.
• Installed NEW apron chains on the upper inlet cover.
• Replaced the lower left bearing on the steel discharge belt tail pulley.
• Installed a NEW grizzly.
• Repaired left track adjuster.