ASGCO
Semi-Cerami Pulley Lagging
|
Corrects Belt Slippage and Premature Wear
Semi-Ceramic™ Pulley Lagging provides the solution when conventional rubber lagging fails to correct belt slippage and wears prematurely.
More information
Data
Corrects Belt Slippage and Premature Wear
Semi-Ceramic™ Pulley Lagging provides the solution when conventional rubber lagging fails to correct belt slippage and wears prematurely.
CORRECTS BELT SLIPPAGE AND PREMATURE WATER
Newly Improved Ceramic Tile – provides robust performance in dry, wet, or muddy applications.
High Grade – aluminum oxide ceramic
Bonding Strength – that is superior to others, due to 3mm of our neoprene compound vulcanized into bottom-side of the lagging.
Pre-Chemical Backing – for ease in installation
Increase Productivity – by delivering increased traction between the conveyor belt and pulley, allowing for lower belt tension than with rubber lagging.
Reduce Down Time – on non drive pulleys, where pulley change-out due to excessive wear is difficult.
Rounded corners – allow for better adhesion between the rubber and the tile.
CORRECT BELT SPILLAGE
SemiCeramic Lagging – for smaller pulley’s non-drive pulley’s and bend pulley’s.
Ceramic Tiles – embedded in rubber on all sides and separated by a horizontal groove for dispelling water and dirt.
Available in Rolls – use only what is needed.