MLT
SANDBLASTING / TUMBLASTING BELTS
|
These belts are used in tumblasting machine to clean foundry pieces after furnace unload. In order to resist to these constraints, our belts are manufactured with a very high resistant rubber (abrasion index of 50 mm3), which is really important to bear with the sand blastings up to 656 feet/second. Our holes are completely cylindrical in order to maximize the sand evacuation. Cleats, guides & treads are integraly moulded.
These belts are used in tumblasting machine to clean foundry pieces after furnace unload. In order to resist to these constraints, our belts are manufactured with a very high resistant rubber (abrasion index of 50 mm3), which is really important to bear with the sand blastings up to 656 feet/second. Our holes are completely cylindrical in order to maximize the sand evacuation. Cleats, guides & treads are integraly moulded.
Excellent output and exceptionnal resistance
Hole on request (Ø, distance between 2 holes, treads).
With or without cleats enterely moulded
With or without center guide entirely moulded
Breaking tension /
Up to 5710 PIW
Carcass /
Special carcass without steel components but stiffened
Rubber /
Rubber with tyre rubber quality : abrasive resistant (index 50 mm3), oil & grease resistant (index 115 mm3) or heat retardant (index 115mm3)
Holes /
Perfectly cylindrical : no jamming, excellent blast sand evacuation
Endless length /
Up to 256 inches
Width /
Up to 79 inches